Universal remote adapter for the Revox B285 and B286 receivers
Last updated August 19, 2015

I sell this on eBay for $75 or buy direct for $70 + shipping of $8 within the US or $16 outside.

Contact me at scott@revoxremotes.com

You must be thinking the Revox B285/286 is already remote capable with the B201, B201CD and B205 remotes, but, these remotes are big, clunky, hard to find and expensive. Oh, want one other thing, the remote protocol that Revox used in these units is super old and not compatible with any universal remotes so you can't integrate it with your other units with in one Pronto or Harmony remote. That's where this remote adapter comes in. This remote adapter is controlled via modern SIRC Sony IR protocol which is arguably one of the most supported IR protocols in the world. It will make your B285/286 controllable from any universal remote capable of sending Sony VCR player codes including the Pronto and Harmony!

This unit controls most of the functions supported by the original remote. Go down to the picture of the remote control for a list of all the supported functions.

Installation
Turn off the power to the tape deck. Plug the remote adapter into the Serial Link connector on the back of the receiver. Now power can be turned back on. The light on the front of the remote adapter should be on. The remote adapter does not need any external power. It gets its power from the receiver.

The universal remote adapter is able to control 20 functions on the Revox B285/286.

The remote adapter can be programmed to respond to various Sony VCR codes. To select between them there are jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover. Located near the front window is a jumper block. These jumpers configure what type of Sony VCR codes the unit will respond to. See the table below for a list of jumper settings.

JMP1

JMP2

Device
Type

DirecTV Remote

JMP

JMP

Beta VCR

20033

JMP
OPEN
8mm VCR
20034
OPEN
JMP
VHS VCR
20032
OPEN

OPEN

LDP

----

LDP = Laser Disc Player

Configuring the DirecTV Universal Remote
To program the DirecTV remote first slide the switch at the top to AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5-digit device code from the table above. If done correctly the green light will blink twice after the last digit is entered. On the DirecTV remotes the REC button needs to be pressed twice to activate record. DirecTV manual and code list.

For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here

 

Maker of wireless remote adapters for vintage tape decks. Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.